







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Wylie, TX: What It Costs and How Long It Takes
An asphalt driveway in Wylie typically runs $3,500 to $9,000 for new paving, and resurfacing an existing drive lands lower since you’re not tearing out and hauling off the old base. Most residential jobs take one day for tear-out and grading, one day to lay and compact the asphalt, and then a cure window of a few days before you park on it. Call (888) 343-9048 and we’ll walk your drive and give you a written number.
How We Actually Build One, Start to Finish

Asphalt work is unforgiving about sequencing. The base matters more than the blacktop you see, and if we rush the front end of the job you’ll be back on the phone in three years watching it crack. Here’s the real order of operations on a Wylie driveway.
Stage 1: Walk-through and layout (day 1, about 45 minutes)
We measure the drive, check the slope away from the slab, and look at what’s underneath. This is where you decide the width (10 feet for a single car with door clearance, 12 to 16 for two), whether you want a widened apron at the street, and whether you’re keeping the existing footprint or turning a straight drive into something with a curve or a turnaround pad. We also confirm the drainage path, because in Wylie water has to go somewhere and it shouldn’t go toward the house.
Stage 2: Tear-out and base prep (day 1, most of the day)
Old asphalt, broken concrete, or turf comes out and gets hauled off. We excavate to depth, then bring in and compact the base in lifts, usually 4 to 6 inches of crushed stone or flexible base material depending on soil and load. This is the slow part, and it’s also the part that decides how the driveway holds up. On Wylie’s clay, we pay close attention to grading so water sheds rather than sits against the base.
Stage 3: Grading, compaction, and inspection (end of day 1)
We cut the final grade, run a plate compactor and roller over the base, and check the cross-slope. If your drive ties into a public sidewalk or the street apron, the work may need to meet city standards, and we confirm that before a single ton of asphalt shows up. You don’t have to chase anything down; we handle the paperwork side and tell you what, if anything, needs a permit.
Stage 4: Paving and rolling (day 2)
Hot asphalt goes down in lifts, typically 2 inches compacted for a residential drive, and gets rolled while it’s still workable. Edges get tamped and dressed. This is where a driveway takes its final shape and density, and it’s a one-shot deal: once it cools, you’re not fixing a soft spot without cutting it out. You’ll see the finished surface by end of day.
Stage 5: Cure and handoff (days 2 through about 5)
Asphalt stays soft while it cures. Keep vehicles off for a few days, keep heavy loads off longer, and plan to avoid sharp turns or parking with the wheels cranked hard for the first stretch. We walk the job with you, talk through sealing (usually after the first 6 to 12 months, then every few years), and hand over the written workmanship terms.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Asphalt isn’t one product. What you pick at the estimate stage decides how the drive performs and what it costs.
- New asphalt vs. resurfacing over existing: A full new build gives you a fresh base and the longest life. Resurfacing or an overlay is cheaper and faster, but only works if the existing base is still sound and not heaved or cracked through. On clay, we’re honest about which drives are good overlay candidates and which aren’t.
- Base thickness and material: A standard residential base holds up to normal cars. A heavier base matters if you’re parking a trailer, an RV, or a work truck. The difference shows up in price and in how the drive handles soil movement.
- Asphalt mix and lift depth: Standard hot-mix is the everyday choice. A thicker compacted lift gives more durability on a long or heavily used drive. You’ll choose based on load and how long you plan to stay.
- Edging and borders: Asphalt alone has soft edges that can ravel. A concrete or stone edge holds the mat together and cleans up the look, and it’s a modest add to the job.
- Sealer and finish: Sealing protects against sun and water and restores the black finish. You can seal on a schedule, and we’ll tell you the honest timing for your drive rather than selling it on day one.
What Asphalt Driveways & Resurfacing Costs in Wylie, TX

Here’s the range to plan around. Every number below is a realistic Wylie figure, not a national average.
| Line item | Typical Wylie range |
|---|---|
| Asphalt driveway paving (new) | $3,500 – $9,000 |
| Full driveway replacement | $5,000 – $14,000 |
| Resurfacing / overlay (existing base sound) | Lower end of the paving range, priced per drive |
| Driveway sealing | $250 – $700 |
Four things push a job toward the high end. Size and layout: a long drive, a turnaround pad, or a widened apron adds square footage and material. Existing condition: a base that’s heaved, cracked through, or sitting on poorly drained clay means more excavation and more base material. Access and haul-off: tight lots and long carries slow the crew and add disposal cost. Load and spec: a heavier base or thicker lift for trailers and trucks costs more but saves you a rebuild. Your written estimate spells out base depth, asphalt depth, square footage, edging, haul-off, and whether any permit or inspection fee applies. What it doesn’t cover is sealing down the road, any utility relocation nobody flagged, or work outside the drive footprint like a walkway or patio.
See the difference
Before
After
Before
After
Before
AfterWhat Wylie’s Lots Do to an Asphalt Drive
Wylie grew up fast. The town flipped from a small farm community into a Collin County bedroom suburb in about two decades, and almost all of the housing stock in ZIP 75098 is 1990s-to-present subdivision homes built on former blackland prairie pasture. That history matters for asphalt. Blackland clay swells when it’s wet and shrinks when it dries, and on flat-to-gently-sloped lots across the newer subdivisions, water that doesn’t drain gets pushed toward the slab, the fence line, and the drive. That’s why base prep and grading, not the blacktop, get most of our attention here. A drive poured over a poorly drained base in Wylie will show edge cracking and settlement long before one that was graded and compacted right. We see the same story off streets like those running through the older downtown grid and the newer subdivisions both, and if you’re pairing a drive with fencing or site work, homeowners often combine it with Chain Link Fence in Wylie or ADU Site Prep & Utilities in Wylie. If the wider scope is on your mind, this fits neatly as part of a full Driveway & Pavers in Wylie project, and you can see all our options on the Driveway & Pavers page.
Serving Wylie, TX – Our Local Coverage Area
We serve Wylie and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Wylie

Most residential jobs take two working days on site, with several days of cure before you park on it. Tear-out and base prep fill day one, paving fills day two, and the drive needs a few days to set before normal vehicle traffic. Call (888) 343-9048 for a timeline based on your specific lot.
Not always, but it depends on whether the work touches a public sidewalk, the street apron, or right-of-way. A private drive inside your own lot usually doesn’t need a separate permit, while anything tying into city infrastructure may. We confirm the requirement before work starts and pull what’s needed.
Yes, when the base is still sound and the surface isn’t cracked through or heaved. A resurfacing overlay costs less and skips full tear-out, but it won’t fix a failing base, and on Wylie’s clay a base that’s moved is usually a rebuild. We’ll tell you honestly which one your drive needs.
Resurfacing generally sits below full replacement, and full paving in Wylie runs $3,500 to $9,000 with replacement at $5,000 to $14,000. Exact cost depends on square footage, base condition, and edge work. Call (888) 343-9048 for a written line-item quote, and estimates are free.
All our work is covered by the 730-Day Done Right Promise, one of the longest workmanship guarantees in the residential construction space. If something isn’t right, we make it right. Calls are answered by a live person 24/7, and our technicians are background-checked and arrive in uniform.
Get a Free Estimate on Your Wylie Driveway
If your asphalt drive is cracking, pooling, or just worn out, the fastest way to know what it’ll cost is to have someone walk it with you. Call (888) 343-9048 and a live person picks up, any hour. We’ll schedule a free on-site estimate, look at the base and the grade, and hand you a written quote with the number you see being the number you pay. Serving Wylie and the surrounding area, with upfront pricing and no surprises.
Written by the team at Groundwork Construction Co.












