







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Sachse, TX: What It Costs and How It’s Done
Asphalt driveways in Sachse typically run $3,500 – $9,000 for new paving, and resurfacing an existing drive usually lands between $1,800 – $4,000 depending on size and condition. Most Sachse driveways are 400 – 650 square feet, laid in two lifts, and finished within two to four working days of prep. Call (888) 343-9048 and we’ll walk your lot and hand you a written line-item quote for free.
How We Lay and Resurface Asphalt in Sachse, Step by Step

Asphalt work is a sequence, not a single visit. Here’s what actually happens from the morning we pull up to the morning you park on it.
Stage 1: Walk the lot and set the grade (day one, about an hour)
We measure the footprint, check where water currently runs off the slab, and look at what drives up to your garage apron. In Sachse, that grade check matters more than the asphalt itself: blackland clay under a newer subdivision lot wants a specific cross-slope so water leaves toward the street instead of puddling at the garage door. You decide the shape here, including whether to widen or add a turnaround.
Stage 2: Demo and base prep (day one, four to six hours)
Old asphalt gets broken and hauled off, or milled if we’re overlaying. Then we dig out the subgrade, compact the clay, and bring in a crushed limestone base, usually 4 to 6 inches for a residential drive. That base is where most of your money goes, and it’s the part nobody sees after the blacktop is down. You approve the base depth before we pour stone.
Stage 3: Grading, drainage, and any edge work (day one into day two)
We set the base to a final grade, tie in any culvert or drainage channel, and form the edges. If a concrete apron or a strip of border pavers is going in along the garage or the street, that has to be set now, not after paving. This is the stage where you decide edge treatment and whether to add a widened approach.
Stage 4: Paving (day two, three to five hours)
Hot-mix asphalt arrives at roughly 300 degrees and gets laid in two lifts: a base course and a finish course, usually 2 inches compacted each. We roll it while it’s hot to compact and seal the surface. Roller passes take time, and a rushed job shows up as a wavy or porous drive within a year. Plan on two lifts for anything over 400 square feet.
Stage 5: Cure and the two-week rule (day two, then patience)
You can walk on the drive the same evening. You can drive on it after about 48 to 72 hours. But full cure takes two weeks to a month, and in North Texas summer heat, heavy loads on a fresh drive leave ruts that never come out. We give you a written cure schedule, and we come back for a final inspection after the drive has cured.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Pavement Options You’ll Choose Between
Once we’re past the base work, the real decision is what goes on top and how it’s finished. Here’s what actually matters.
- Hot-mix asphalt, standard grade: The workhorse. Costs the least per square foot, $3,500 – $6,500 for a typical Sachse drive, holds up to Texas heat, and is the easiest to patch later. It fades to gray over the first two summers.
- Hot-mix with a heavy base: Adding 2 inches of compacted limestone under the asphalt pushes the job toward $7,000 – $9,000 but is the right call if your drive takes a heavy truck or you’re paving over clay that has shifted before.
- Overlay / resurfacing: If your existing asphalt is sound, we mill or clean the surface and lay 1.5 to 2 inches of new hot-mix over it. Cheaper, faster, and looks new; only works when the base underneath is still intact.
- Seal coat: A thin protective coat applied to asphalt after it cures. It slows sun damage and keeps the surface looking fresh. It does not fix an unstable base, and it’s not a substitute for repaving.
- Edge and border treatment: Concrete curbing, a paver ribbon along the garage apron, or a smooth saw-cut edge. Atlas and Tamko products come up when the surrounding hardscape is going in at the same time, and a good edge detail is what makes an asphalt drive look finished instead of laid.
See the difference
Before
After
Before
After
Before
AfterWhat Asphalt Driveways & Resurfacing Costs in Sachse, TX

Expect $3,500 – $9,000 for a new asphalt drive and $1,800 – $4,000 for resurfacing an existing one. Seal coats run below both figures, and a bordered or widened drive sits at the higher end. Here’s the breakdown by line item.
| Line item | Sachse range |
|---|---|
| New asphalt driveway, typical 400 – 650 sq ft | $3,500 – $9,000 |
| Overlay / resurfacing over sound asphalt | $1,800 – $4,000 |
| Full replacement (demo + new base + new asphalt) | $5,000 – $14,000 |
| Sealing the finished drive | $250 – $700 |
What pushes a job to the high end: footprint size, how deep we need to go on base (deeper on expanded clay), a full demo versus an overlay, adding drainage or a culvert, and a widened or bordered approach. What’s in a written estimate: demo, haul-off, base material and compaction, both asphalt lifts, rolling, cleanup, and a cure schedule. What usually isn’t: drainage structures beyond a simple culvert, driveway gates or automatic openers, and any landscaping repair around the edges. Our estimates are upfront and fixed, and the number you see is the number you pay. Call (888) 343-9048 for an exact quote – the estimate is free.
What Sachse’s Lots and Clay Mean for Your Driveway
Sachse’s housing stock is mostly 1990s through 2010s brick-veneer subdivisions, so the driveway work here is rarely about a driveway that’s simply worn out. It’s about a base that was built on blackland-prairie clay and has been moving under a slab since the house went up. The clay swells every spring and shrinks every dry August, and that seasonal cycle is what cracks and heaves asphalt around subdivisions off Sachse Road and along the Woodbridge and Sachse Estates pockets. Homes that were built with a builder-grade 2-inch base often show alligator cracking and sunken edges before the drive is a decade old. There’s a second wrinkle: lots that sit against remaining pasture or a neighboring acreage property need the driveway’s drainage resolved where the subdivision meets open field, because nobody graded that boundary for you. It’s why we walk the grade before quoting and why our estimates include a base-depth line, not just a surface number. Most people in Sachse are paving or resurfacing an outdoor project in one pass, and many homeowners pair this with a Chain Link Fence in Sachse or a bit of ADU Site Prep & Utilities in Sachse so the site gets graded once. We cover all of Sachse and the surrounding corridor.
Serving Sachse, TX – Our Local Coverage Area
We serve Sachse and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Sachse

Plan on two to four working days from demo to finished pavement. Base prep and grading take a full day, paving is a half day, and the cure schedule runs two to four weeks after that. Call (888) 343-9048 and we’ll put your project dates in writing.
Most Sachse residential driveways don’t need a separate building permit, but any change to the approach, curb cut, or drainage that meets the street does. HOA review in most of the subdivisions is a separate step and can dictate material and width. We handle the paperwork and inspections the project requires, and we tell you upfront which ones apply.
Yes, if the base is sound – resurfacing costs $1,800 – $4,000 versus $5,000 – $14,000 for a full replacement. If the clay under the drive has already caused movement, an overlay will crack within a season, so we check the base before recommending it.
New asphalt runs $3,500 – $9,000 and resurfacing runs $1,800 – $4,000 for typical Sachse lots. The biggest variable is base depth, not the topcoat. Call (888) 343-9048 for a free written quote – no charge to look.
Every asphalt driveway and resurfacing job we do is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. That covers workmanship, and it’s in writing. Our technicians have up to 12 years of experience; a real person answers at any hour.
We’d rather show you a driveway plan than sell you one over the phone, so we start with a free on-site estimate: we walk the grade, check the base, and give you a fixed written number before any equipment moves. You’ll see the line items, the base depth, and the cure schedule in writing. That afternoon project is often part of a full Driveway & Pavers in Sachse scope, and our Driveway & Pavers team can price everything together. Call (888) 343-9048 – a person answers, every time.
Written by the team at Groundwork Construction Co.












