







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Rowlett, TX: What It Takes and What It Costs
A chain link fence in Rowlett typically runs $3,500 to $9,000 and takes one to three days to install on a standard subdivision lot. Here’s the straight answer: it’s the fastest, most durable fence you can put around a yard in North Texas, and on Rowlett’s clay soils the posts either become your best friend or your worst enemy depending on how deep they go. Call (888) 343-9048 and we’ll walk your property line and give you a written, line-item quote before anyone touches a shovel.
Chain link is the workhorse fence. The galvanized coating protects the steel from rust, the fabric stretches tight between posts set in concrete, and the whole thing holds up for decades if it’s put in right. Most of our Rowlett installs fall into three camps: a straight perimeter run around a suburban backyard, a dog fence with a self-closing gate, or a short run of commercial-grade chain link along a driveway or side yard.
How We Build a Chain Link Fence in Rowlett, Step by Step

The sequence matters more than the brand of the fabric. Here’s what actually happens on a job.
Day 1, morning: Layout and call-before-you-dig
We walk the property line with you, paint the corners, and confirm gate locations. Before any dig starts, the 811 utility locators come out and mark gas, water, and electric. This usually takes 2 – 3 business days to schedule, so it’s the first thing we book. If a water or sewer line runs right where a post needs to go, we shift the post or re-route the run, and that decision belongs to you.
Day 1, afternoon: Post holes and concrete
We dig holes roughly 24 – 30 inches deep on a standard install, more on a corner, gate post, or a lot with a slope. Posts get set in concrete and need a day or two to cure before they carry tension. On Rowlett’s shrink-swell clay, this is where a cheap install shows its weakness later. Shallow posts in fill dirt will heave after a wet spring, and a leaning fence line is nearly impossible to straighten once the concrete sets.
Day 2 – 3: Rails, fabric, and tension
Top rail goes in first, then the tension wire or bottom rail depending on the style you choose. The fabric gets pulled tight enough that it doesn’t sag between posts. We set the gates last so they hang square and latch clean, then tension them. This is the stage where the fence either looks crisp or looks like a science project.
Final: Walkthrough and cleanup
We walk the line with you, check every gate, and haul off the concrete residue. That’s the whole job. Most standard residential runs finish in a single extended day or two.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make on a Chain Link Fence
- Fabric height and gauge: 4 ft is the standard residential height and the cheapest line to run. 5 ft and 6 ft cost more in material and posts but keep a bigger dog in and give more privacy with slats. Gauge matters too: 11.5-gauge fabric is the heavier residential grade and resists bending; 12.5-gauge is lighter and cheaper but dents easier.
- Post and rail weight: 1-5/8 inch line posts are standard, 2-3/8 inch gives a stiffer line and better gate support. Heavier posts are worth it on gate sections and long runs.
- Galvanized vs. vinyl-coated: Standard galvanized is the most affordable and rust-resistant in its own right. Vinyl-coated chain link (usually black or green) costs 15 – 25% more but blends into landscaping better and adds a layer of weather protection.
- Privacy slats: Inserted into the chain link, they turn an open fence into something closer to wind-blocking and private. They add cost and weight, and they catch wind and debris, so post depth matters more once you use them.
- Gate type: A basic walk gate, a double drive gate, or a self-closing gate for pets or pool access. Gate hardware is where cheap installs fail first, so we spec heavier hinges and latches.
If the fencing is part of a wider yard plan, our Fence Installation in Rowlett page covers the full range of fence work we handle here. This page is specifically about chain link.
What Chain Link Fence Costs in Rowlett, TX

Expect $3,500 to $9,000 for a chain link fence in Rowlett. Here’s what pushes a job toward one end or the other:
| Factor | Low end | High end |
|---|---|---|
| Linear footage | ~100 ft | 300+ ft |
| Fence height | 4 ft | 6 ft |
| Material | Galvanized | Vinyl-coated |
| Gates | One walk gate | Multiple or double drive gate |
| Terrain | Flat lot | Sloped or rocky lot |
Size is the biggest mover. A short 100-ft dog run sits at the bottom of the range; a full perimeter around a quarter-acre keeps climbing. Terrain matters in Rowlett specifically: a lot with a slope or packed clay needs deeper posts and sometimes a stepped fence line, and that adds labor. Extra gates add cost each. And privacy slats, vinyl coating, and heavier post specs each push the number up.
A written estimate covers posts, fabric, gates, concrete, and haul-off. It doesn’t typically cover removing an old fence unless we quote it separately, and it doesn’t cover fixing a buried utility conflict that only shows up after the dig. We disclose both up front. The number you see is the number you pay, backed by our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Rowlett Homes Do to a Chain Link Fence Install
Rowlett is a Lake Ray Hubbard shoreline suburb that filled in as planned subdivisions through the 1980s and 2000s, so most of the homes here are 20 to 40 years old and the work is renovation and repair, not new build. That changes fence work in specific ways.
The clay soils are the big one. North Texas shrink-swell clay moves with the seasons, and a chain link fence built on shallow footings in that clay will start to lean after a few wet springs. We set posts deeper and use more concrete on the Rowlett jobs where we’ve seen that pattern.
On lots near the 75088 and 75089 lake corridors, shoreline and floodplain rules can affect setback placement, so we check the property line against the lot’s recorded boundaries before we dig. And the spring hail and straight-line wind storms that roll through Rowlett mean a chain link fence gets tested hard. We build to take that wind load.
HOA rules vary by subdivision, so if your neighborhood has one, check its fence spec before we order materials. If you’re adding a fence alongside other yard work, the Rowlett service-area page shows everything we cover in the city.
Serving Rowlett, TX – Our Local Coverage Area
We serve Rowlett and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in Rowlett

Most residential chain link fences in Rowlett go up in one to three days after utilities are marked, with the 811 locate adding a few days to the front end. Call (888) 343-9048 to schedule an estimate and we’ll give you a realistic timeline for your lot.
Rowlett permits depend on height and location, so we confirm the current City of Rowlett requirements before installation and pull what’s needed. Call (888) 343-9048 and we’ll tell you what your specific fence line requires.
Yes, with proper post depth and concrete. The clay is the reason cheap shallow installs fail here. We set posts deeper and spec heavier posts on gate sections so the fence holds through wind and seasonal soil movement.
Most chain link fences in Rowlett run $3,500 to $9,000 depending on footage, height, material, and gate count. Call (888) 343-9048 for an exact written quote at no charge.
Every chain link fence we install is covered by the 730-Day Done Right Promise. That guarantee covers workmanship, and we arrive in uniform with an upfront price so there are no surprises after the job.
If your fence project sits alongside a larger plan, homeowners often pair it with ADU Site Prep & Utilities in Rowlett or Door Installation in Rowlett and use our Fence Installation service as the anchor.
Get a Free Chain Link Fence Estimate in Rowlett
A free on-site estimate for your chain link fence in Rowlett starts with a call to (888) 343-9048. We’ll ask about your property line, what the fence is guarding, and any gate needs, then set a time to walk it. You’ll get a written, line-item quote with no surprises. A live person answers around the clock, so there’s no voicemail to wait on.
Written by the team at Groundwork Construction Co.












