







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Fate, TX: What the Job Actually Involves
A chain link fence in Fate, TX usually runs $3,500 – $9,000, and most residential lots land at the lower half of that because the runs are short and the ground is open. A typical 150- to 300-foot perimeter takes two to four working days start to finish: line and permit check first, posts set in concrete second, mesh stretched and gates hung last. Call (888) 343-9048 for a free on-site estimate and you’ll get a written line-item quote before anything is ordered.
How We Build a Chain Link Fence, Stage by Stage

Chain link isn’t complicated, but the difference between a fence that stays tight for twenty years and one that sags by year three is in the sequencing. Here’s the order we work in.
Stage 1: Walk the line and confirm setbacks (day 1, about 1 – 2 hours)
We mark the fence line with the homeowner and check it against the plat and any recorded easement. On a Fate lot, the common snag is a utility easement running along the back property line, which limits where posts can go. You decide the exact line and gate placement here. Getting this right on day one is cheaper than moving posts on day three.
Stage 2: Permit and utility locate (1 – 5 business days, depending on the town)
Fences under a certain height are often exempt from permitting, but corner lots and anything near a drainage easement can trigger a review. We pull what’s required and call for the utility locate so nobody drives a post through a water or gas line. This is the stage where scheduling can stretch, and we tell homeowners that up front rather than pretending it’s instant.
Stage 3: Post setting (day 2, roughly 4 – 6 hours)
Terminal posts at corners and gates get set deeper and with more concrete than line posts. In Fate’s black clay, that matters: the soil shrinks and swells with the seasons, and a shallow post will heave. We set posts in concrete, plumb them, and let them cure before any tension goes on the mesh. If you want this fence to be part of a Fence Installation in Fate plan that includes a front section in another material, we coordinate the post spacing so the two sections meet cleanly.
Stage 4: Rails, mesh, and tension (day 3, 3 – 5 hours)
Top rail goes on first, then the mesh is unrolled and stretched with a come-along, not by hand. This is where a cheap job shows itself: mesh that isn’t tensioned properly will ripple and sag within a season. You decide at this stage whether you want a top rail, a bottom tension wire, or both. Both is sturdier; a top rail alone is the standard look.
Stage 5: Gates and final walkthrough (day 4, 1 – 2 hours)
Gate frames get hung, hinges set, and the latch checked for a clean close. We walk the whole line with the homeowner, test the gate, and clean up the site. That final walk is when we document the install for the 730-Day Done Right Promise, so there’s a written record of what was built and when.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Change the Fence
Chain link looks uniform from the street, but there are four or five decisions that separate a budget run from a fence that holds up under North Texas weather.
- Gauge and coating: 11.5-gauge mesh is the residential standard; 9-gauge is heavier and costs meaningfully more, but it resists bending from dogs and kids. Galvanized lasts, but vinyl-coated (usually green or black) resists rust longer and blends into landscaping. Black-coated is the most common pick in newer Fate subdivisions because it disappears against brick and stone.
- Post schedule: line posts every 8 to 10 feet. Stretching that spacing saves a little money and costs you in stability. We don’t recommend going past 10 feet.
- Height: 4-foot is the budget choice, 5-foot the most common for backyard privacy from neighbors, 6-foot for dogs that climb or jump. Each step up adds to post and mesh cost.
- Top rail vs. tension wire: a top rail gives the fence a finished line and stiffens the whole run. A bottom tension wire keeps the mesh from lifting at ground level. Both together is the sturdiest configuration.
- Gate hardware: a standard walk gate with self-closing hinges is fine for most homes. If a driveway gate is in the plan, that’s a different conversation and a different budget.
We source mesh and fittings from suppliers whose coatings hold up in North Texas sun and clay, and where a matching finish matters we’ll spec CertainTeed or GAF products on the adjacent structures so the colors don’t fight each other. If your project includes a detached structure, homeowners often pair this with ADU Site Prep & Utilities in Fate, since both involve trenching and site grading.
What Chain Link Fence Costs in Fate, TX

Expect $3,500 – $9,000 for a residential chain link fence in Fate, with the wide range driven mostly by linear footage and height. A short 4-foot run around a standard subdivision backyard sits near the bottom; a full acreage perimeter at 6-foot with a drive gate lands at the top.
Here’s what moves the number:
- Linear footage: the single biggest driver. 150 feet and 400 feet are different jobs.
- Height and gauge: 6-foot 9-gauge is roughly double the material cost of 4-foot 11.5-gauge per foot.
- Ground conditions: rocky ground or existing concrete along the line means more labor to set posts. On Fate acreage lots with buried debris or old fence footings, post holes can slow down considerably.
- Removal and disposal: tearing out an old fence and hauling it off adds a line item. We quote it separately so you can see the number.
- Gates and corners: every gate, corner, and terminal post costs more than a straight line post, and a property with lots of turns costs more than a simple rectangle.
A written estimate from us lists footage, height, gauge, coating, post spacing, gate counts, removal, and disposal as separate lines, with the total locked in. What it won’t include unless we discuss it: landscaping repair after the work, sod replacement, or anything the town requires that wasn’t visible during the walk. Our Fence Installation service page covers the broader scope if you’re planning more than chain link.
See the difference
Before
After
Before
After
Before
AfterWhat Fate Homes Specifically Do to This Job
Fate, TX (ZIP 75132) is a Rockwall County town in the middle of rapid build-out along the SH-66 corridor, and that’s the thing that shapes fence work here more than anything else. New custom and tract homes are going up right beside large-lot rural acreage and older ranch parcels, so a chain link crew here swings between two very different jobs in the same week: a clean subdivision backyard with an open, graded lot, and an acreage parcel with site work, drainage to figure out, and buried lines nobody has a map for.
The soil compounds it. North Texas expansive black clay shrinks and swells with the seasons, which is why post depth and concrete matter more in Fate than they would on sandy ground. We set terminal posts deeper and don’t shortcut the cure time. Downpours in spring also test drainage, and a fence line placed carelessly across a low spot will pond water against the posts. On acreage, we walk the grade first and adjust the line. In newer subdivisions, HOA rules on fence color and height often override anything you’d otherwise choose, so check before you order black-coated mesh. And when a project runs alongside other work, the count of trades on site matters; homeowners often pair this with Door Installation in Fate during a larger exterior refresh. See our Fate service-area page for what else we cover.
Serving Fate, TX – Our Local Coverage Area
We serve Fate and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Fate

Most residential chain link fences in Fate take two to four working days, with the permit and utility locate stage adding a few days of lead time that’s often out of our hands. The install itself is fast; the scheduling is where patience is needed. Call (888) 343-9048 and we’ll walk you through what your specific lot will require.
Many residential fences are exempt from a full permit, but corner lots, easements, and drainage areas can change that, so we check before we dig. We pull what’s required and call for the utility locate regardless. Call (888) 343-9048 and we can tell you what your address needs.
Residential chain link fence in Fate typically runs $3,500 – $9,000, driven by footage, height, gauge, ground conditions, and gate count. Removal of an old fence is quoted separately. Call (888) 343-9048 for a written line-item estimate; the free on-site walk is what makes the number accurate.
We keep damage minimal by setting posts at the fence line and staying out of the interior yard, though some turf disturbance along the line is unavoidable with any post-in-ground fence. We don’t promise zero disruption; we promise you’ll know what to expect before we start. Call (888) 343-9048 to schedule the estimate.
Workmanship on every chain link fence we install is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction. Material warranties come from the manufacturer. Call (888) 343-9048 for the details on your job.
Get a Free Chain Link Fence Estimate in Fate
A free on-site estimate for a chain link fence in Fate takes about 30 minutes. We walk the line with you, measure the footage, check the ground and any easements, talk through height and coating options, and leave you with a written line-item quote at upfront pricing, no surprises. Call Groundwork Construction Co. at (888) 343-9048 to schedule it. Live person, 24/7, so you reach a human whenever you call.
Written by the team at Groundwork Construction Co. of Allen.












