







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Allen, TX: What It Costs and How Long It Takes
Asphalt Driveways & Resurfacing in Allen runs about $3,500 to $9,000 for a full new paving job, and a fresh seal coat on an existing drive lands at $250 to $700. A new asphalt drive is typically a 3 to 4 day job: one day to strip and grade, one to pour the base and binder, one to run the finish course, and the rest for compaction and cure. Call (888) 343-9048 for a free on-site estimate and a written line-item quote.
How a Groundwork asphalt job actually runs, day by day

Most homeowners have never hired a paving crew before, so here’s the honest sequence. No hand-waving about “we handle everything.”
Day 1: tear-out and site check
We cut back the existing surface, remove the failed asphalt, and confirm the base underneath. This is where the real diagnosis happens. If the sub-base is pulverized from years of Texas clay movement, resurfacing over it just buys you a year or two. On most first-generation Allen subdivisions, that base is still solid. On a few, it isn’t. You’ll see exactly what we see and we’ll say so out loud.
Day 1 (continued): grading and drainage
We cut the subgrade to a proper fall so water runs off the drive and not toward the slab or the garage wall. North Texas blackland-clay soil is unforgiving: it swells when wet and shrinks when dry, so the subgrade gets compacted in lifts to hold grade. If the drive currently pools water near the garage, this is the stage where that’s fixed, not six weeks later.
Day 2: base course
A crushed-stone base goes down and gets compacted. Thickness is a decision point for you: 4 inches is the minimum for a standard residential drive; 6 inches is what we recommend on Allen drives that see a heavy truck or an RV. It’s a few hundred dollars more now and it’s what keeps the surface from rutting in the first two summers.
Day 3 and 4: binder, finish course, and compaction
The hot-mix binder goes down, then the finer finish course. Between courses the surface gets rolled and the edges tamped. You choose the finish coat grade at the estimate, and you should ask about the asphalt mix’s binder content. Higher-binder mixes cost more and hold up better under summer heat.
Cure and the sealing decision
Stay off the new surface for 24 to 48 hours. Then the driveway is done except for sealing, which should be scheduled 6 to 12 months after install, once the asphalt oil has off-gassed. That’s the best time to lock it in, not the next week.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
Asphalt is not one product. Here’s what actually comes up at the estimate table.
- Standard hot-mix asphalt: the workhorse. 2 to 3 inches thick on a 4-inch base, and it holds up well in Allen’s summer heat. Costs the low end of the range and is the right call for a normal two-car drive.
- Heavier-duty asphalt: 3 to 4 inches of hot-mix on a 6-inch base. Costs $1,200 to $2,500 more than the standard build on a typical drive. Suits a long pull-through drive, a workshop pad, or a home with a boat or trailer.
- Seal coat options: an asphalt-emulsion sealer is the standard $250 to $700 choice for a typical Allen drive. A polymer-modified sealer costs more and lasts longer, and it’s the better pick on drives shaded most of the day.
- Edge treatment: asphalt is only as strong as its edges. A compacted gravel shoulder is the budget choice; a concrete curb costs more and is what keeps a driveway from unraveling after a hailstorm or a heavy rain event.
- Crack fill and patching: if you’re resurfacing rather than replacing, a proper hot-pour crack fill is not optional. Filling cracks before the seal coat is what stops water from getting under the asphalt and freezing the surface apart next winter.
One brand note: on jobs where the drive ties into a new fence or a patio edge, we’ll spec Belgard borders and edging where a homeowner wants a cleaner transition. Paving is asphalt; the trim work is where brand quality shows.
What Asphalt Driveways & Resurfacing costs in Allen, TX

For Allen, a full asphalt drive usually runs $3,500 to $9,000. Resurfacing an existing drive with seal coat runs $250 to $700 on a typical two-car driveway. The full driveway replacement range, if the base is shot, is $5,000 to $14,000. Five things push the number:
- Drive size: a standard 20 by 20 two-car drive sits at the low end. A three-car or pull-through drive can double it.
- Base condition: if the sub-base is intact, we can resurface. If it’s failed, we’re in full replacement territory.
- Access: a narrow side yard or a gate the crew has to work around adds labor time. If the drive sits behind a fence that needs to come out, that’s a line item.
- Drainage corrections: regrading to move water away from the slab or garage wall costs more than a straight-overlay job.
- Permit scope: in Allen, a new driveway or a change of driveway width or location typically requires a city permit. A same-footprint resurface usually does not. We’ll confirm at the estimate.
Every written quote from Groundwork is line-item: base depth, surface thickness, edge treatment, tear-out, and the seal coat are all spelled out. The number you see is the number you pay. No change orders after the crew arrives.
See the difference
Before
After
Before
After
Before
AfterWhat Allen homes specifically do to this asphalt job
Allen was built out in one long 1990s – 2000s wave, which means most of the drives we work on are original. Those 20 to 30 year old asphalt drives are hitting the end of their useful life at the same moment. In Watters Crossing and Twin Creeks, the failure pattern is the same: an alligator-cracked center where a heavy vehicle sat every summer, softened edges where the clay has shifted, and a surface that has started to ravel from hail. Hail here is a real driver, not a scare line. A bad spring storm pits and chips a seal-coated drive, and the next summer’s heat turns those pits into full cracks. Bethany Ridge drives tend to have the same rut under the right-side wheel track from a car parked outside every night. The good news: almost none of those homes need a structural redo. Most are a proper resurface plus a thicker base at the apron.
Before we can pull an Allen permit, HOA architectural review often has to happen first. And when a homeowner is extending the drive for an RV pad or pairing it with a new Chain Link Fence in Allen, the fence height and setback rules get reviewed by the same committee. We’ll flag both before the crew is scheduled so nothing sits at the curb while paperwork clears.
Serving Allen, TX – Our Local Coverage Area
We serve Allen and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Asphalt Driveways & Resurfacing in Allen

Most Allen asphalt driveways take 3 to 4 working days from tear-out to final compaction, with 24 to 48 hours of cure time before you drive on it. A small resurface or seal coat job is a single-day visit. Call (888) 343-9048 to schedule a free estimate and we’ll give you the exact day count on your property.
For a same-footprint resurface or a seal coat, you usually don’t. A new driveway, a widening, or a change to the location or width of an apron typically does require a permit from the City of Allen, and the HOA review often has to come first. We’ll confirm the scope of the permit at the estimate and pull it before work starts. Call (888) 343-9048 if you’re not sure which side your project is on.
Only if the base is still sound and the cracking is surface level. If the base has failed, a resurface is a band-aid. We’ll core or probe the base at the estimate and tell you plainly which camp you’re in. Call (888) 343-9048 to get the inspection scheduled.
Plan on $3,500 to $9,000 for a new asphalt drive, $250 to $700 for a seal coat, and $5,000 to $14,000 for a full replacement if the base has failed. The driver of the number is base depth, drive size, and drainage corrections. Call (888) 343-9048 for a free written line-item quote.
Our workmanship is covered by the 730-Day Done Right Promise, one of the longest workmanship guarantees in the residential construction space. If it’s not done right, we make it right. Manufacturer warranties on the asphalt mix and sealants carry separately, and we’ll document both in writing. Call (888) 343-9048 to review the terms before you sign anything.
Get a free asphalt driveway estimate in Allen
Call (888) 343-9048 and a live person picks up, day or night. We’ll schedule a free on-site estimate for your Asphalt Driveways & Resurfacing in Allen, walk the drive with you, and hand you a written line-item quote with a fixed price. If the job is part of a wider Driveway & Pavers in Allen plan, or sits alongside ADU Site Prep & Utilities in Allen, we’ll quote the whole scope in one visit. You can also browse our full Driveway & Pavers service and see the rest of what we cover across Allen. Financing is available at 0% for 18 months, and projects over $10,000 get $1,000 off.
Written by the team at Groundwork Construction Co.












