







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Rowlett, TX: What the Job Actually Costs and How Long It Takes
Concrete Driveways & Concrete Work in Rowlett, TX is a roughly 2-to-5 day job for the concrete itself. A standard driveway runs $4,500 to $12,000 in this market, and a full remove-and-replace runs $5,000 to $14,000. A typical pour of 4 to 6 inches reaches drive-ready strength in about 7 days, but schedule the first heavy vehicle at 10 to 14 days. We keep the estimate simple: call (888) 343-9048 for a free, on-site measurement, and you’ll have a written line-item number, not a verbal guess.
From Sod Strip to Cure: Our Concrete Process

There’s no magic in a pour that lasts. The work is in the sequence, and the sequence is where cheap driveways and good driveways separate.
Stage 1: Walkthrough, layout and base measurement (day 1)
We measure the existing footprint, check lot grading and drainage direction, and confirm where the slab meets the street and garage apron. You decide the width, the expansion joint pattern, and whether you want a flare or widening near the street. This walk is also when we look at whether a permit is required for the work.
Stage 2: Demolition and haul-off (day 1 – 2)
Old concrete comes out with a jackhammer and skid steer, and the debris goes in a dumpster the same day. If there’s a failing slab, we inspect the base underneath. Soft, wet, or clay-heavy subgrade is the reason a lot of driveways in Rowlett crack or settle early. Any soft spots get excavated and replaced before new concrete goes in.
Stage 3: Forming and grading (day 2)
Wood or metal forms go in with a string-line level check. We grade for water flow away from the garage and confirm the slope to the street. You decide here on any decorative finish (broom, stamped, exposed aggregate) and on joint placement. Expansion joints go in every 10 to 12 feet and against the structure.
Stage 4: Base, rebar and pour (day 3)
We lay a compacted layer of crushed base (typically 4 inches), set #3 or #4 rebar on a grid, then pour. Concrete mix design matters more in North Texas than most people realize. We use a low-water mix with fibers blended in, which helps against shrink cracking as it cures in the summer heat. Finishers broom or stamp the surface, edge the joints, and cut control joints before the slab sets.
Stage 5: Curing and inspection (day 3 through week 2)
The pour gets a curing compound or a wet cure, and we ask you to keep cars off for 7 days and heavy vehicles for 10 to 14. If the job pulled a permit, the inspection happens after the pour. That’s when we hand you the paperwork for the warranty: the 730-Day Done Right Promise covers our workmanship on the install.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Concrete Options: What You’ll Actually Choose Between
Every driveway decision is a trade-off between budget, lifespan, and how much finish detail you care about. Here’s what the choices really look like.
- Standard broom-finish concrete: The workhorse. $4,500 to $12,000 for a typical Rowlett driveway. It’s low-maintenance, holds color for decades, and it’s what most 1980s – 2000s subdivision homes already have.
- Stamped or decorative concrete: Adds a per-square-foot premium for the pattern and coloring. Looks like pavers or flagstone without joints that shift. Suits homeowners who want a stamped look but don’t want the cost or maintenance of real stone.
- Exposed aggregate: A textured, salt-and-pepper finish. Grippier underfoot, hides tire marks better than smooth concrete, and cost sits between plain and stamped.
- Concrete thickness (4 vs 6 inches): 4 inches is fine for a standard passenger car driveway. 6 inches with rebar is the right call for RV pads, wide driveways, or anything that sees a heavy truck. Ask yourself what’s actually parking on it.
- Control and expansion joints: These aren’t optional. They’re the reason a slab cracks exactly where you want it to and not through the middle of a tire track.
A lot of concrete work here lives inside a bigger plan. If the driveway is one piece of a Driveway & Pavers in Rowlett project, it makes sense to price it that way with our Driveway & Pavers service so nothing gets torn up twice.
What Concrete Driveways & Concrete Work Costs in Rowlett, TX

Concrete Driveways & Concrete Work in Rowlett lands between $4,500 and $12,000 for a standard concrete driveway installation, and $5,000 to $14,000 for full removal and replacement of an existing slab. Here’s the line-item breakdown we build into the written estimate.
| Line item | Typical range in Rowlett |
|---|---|
| Concrete driveway installation (standard) | $4,500 – $12,000 |
| Driveway replacement (remove old, pour new) | $5,000 – $14,000 |
| Driveway sealing (after cure) | $250 – $700 |
What moves the number:
- Square footage. A 20-foot-wide driveway is a much shorter pour than a wide, curved approach that wraps around a corner lot. Most of the range is driven by size alone.
- Existing condition and haul-off. Removing a 6-inch-thick old slab with rebar costs more to break out and dump than a thinner slab with no reinforcement.
- Base work. Rowlett’s shrink-swell clay soils can turn a simple pour into a base-replacement job. Any soft subgrade has to come out.
- Finish. Broom finish is the baseline. Stamped or exposed aggregate adds to the price per square foot.
- Permits. If the driveway needs a permit, that adds cost and a couple of days to the schedule. We pull it and arrange the inspection for you.
What a written estimate includes: labor, concrete, rebar or mesh, base material, form lumber, haul-off, and joint cutting. What it doesn’t include: driveway lighting, drainage channel installation, and any utility relocation. Those are quoted separately if they come up.
See the difference
Before
After
Before
After
Before
AfterWhat Rowlett Homes Specifically Do to This Job
Rowlett is a Rowlett community in ZIP codes 75088 and 75089, but more importantly it’s a shoreline suburb of Lake Ray Hubbard that was mostly built out as planned subdivisions between the 1980s and the 2000s. Most concrete work here isn’t on fresh lots; it’s on driveways that were poured 20 to 40 years ago and are now showing the effects of North Texas heat, spring hail, and shrink-swell clay soils. The common failure pattern we see: a driveway that cracks along a joint, then a piece of the slab settles an inch below the rest. Sometimes the culprit is a tree root pushing the slab up; sometimes it’s failed base under an old pour.
Homeowners in the lake-adjacent corridors near Rowlett Park and the shoreline streets often ask us about drainage run-off direction and slab grading relative to the floodplain. Some residential concrete work near the lake corridor touches shoreline setbacks. For the driveway itself, City of Rowlett permitting and inspection apply, and we handle the paperwork. Homeowners on those bigger lake lots usually want wider approaches and RV pads. If the driveway is part of a bigger backyard build, we often pair it with ADU Site Prep & Utilities in Rowlett or a Door Installation in Rowlett after the garage face gets reworked.
Serving Rowlett, TX – Our Local Coverage Area
We serve Rowlett and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Concrete Driveways & Concrete Work in Rowlett

Most concrete driveway installations take 2 to 5 days of active work, plus 7 to 14 days of curing before regular vehicle traffic. The demo, forming, pour, and finish are the workdays; the curing window is your waiting period. Call (888) 343-9048 for a schedule window built around your project.
A permit is typically needed when concrete work touches the public right-of-way, changes the approach to the street, or affects storm drainage. The City of Rowlett handles those reviews. We confirm during the site walk and pull any required permit as part of the job, so you have one point of contact for the inspection.
Concrete Driveways & Concrete Work in Rowlett runs $4,500 to $12,000 for a standard install and $5,000 to $14,000 for a replacement, with sealing afterward at $250 to $700. The biggest swing factors are square footage, base condition, and finish. Call (888) 343-9048 for an exact number on your driveway; the estimate is free.
No. The written line-item estimate is the number you pay for the scope we agreed to. If a hidden problem turns up (like a failed sub-base under the old slab), we stop and quote the additional work in writing before proceeding. No surprises after the concrete truck shows up.
It covers our workmanship on the install, so if the pour, finish, or joint work fails because of how we did it, we make it right. Concrete cracks can also come from soil movement or tree roots outside our control; we’ll look at it, tell you honestly what caused it, and fix our part. Call (888) 343-9048 to get the estimate and the warranty details in writing.
Get Your Free Concrete Driveway Estimate in Rowlett
Call (888) 343-9048 to schedule a free on-site estimate for Concrete Driveways & Concrete Work in Rowlett. A live person answers 24/7, and we’ll set a time to walk the property, measure the footprint, and talk through finish options. You’ll get a written line-item quote with the price locked to the scope. You’ll also get the 730-Day Done Right Promise, in writing, before the first shovel goes in.
Written by the team at Groundwork Construction Co.












