







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Murphy, TX: What to Expect
Asphalt driveways and resurfacing in Murphy, TX typically cost $3,500 – $9,000, depending on square footage, base condition, and how much edge grading the lot needs. A full mill-and-overlay on a two-car drive usually runs three days: one day to tear out and prep, one to lay the new asphalt, and one to finish edges and clean up. Call (888) 343-9048 and we’ll look at your existing drive and give you a written range before anyone touches it.
How We Hand a Murphy Driveway, Start to Finish

We don’t hand you a number and disappear. Here’s the actual sequence, and where you make the decision that matters.
Day 1 – Walk the property and cut the numbers. Two things get measured first: the driveway’s square footage and the sub-base under it. On Murphy lots platted in the 1980s through 2000s, we often find original builder-grade base that’s already edge-failing, and that changes the job. You decide the finish grade and the drainage slope here, before demo starts.
Day 1 – Demolition and prep. We remove the failing asphalt, push the base back in, and recompact it in lifts. If the existing drive edge has heaved, we re-cut the edge line rather than paving over the movement. Same day, working foreman on site.
Day 2 – Grade and inspection point. Base gets a fine grade, drainage is set so water runs away from the garage slab, and we confirm the finished slope against the garage door threshold before a single ton of asphalt gets laid. This is where low spots and ponded water get caught. The homeowner signs off on the grade before paving.
Day 2 – 3 – Pave and compact. Hot-mix asphalt goes down at the thickness your quote specifies, rolled while warm and compacted throughout, not just at the edges. A two-car driveway is typically a single-day paving operation.
Day 3 – Edge work and cleanup. We cut in clean edges, sweep, and haul out the spoils. Then we walk the drive with you and flag when a seal coat should go on top, usually after the first full season has cured the asphalt.
Most jobs we run in Murphy are completed in a single scheduled visit window, weather permitting. If rain pushes the schedule, we tell you the same morning, not the day of.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Change the Job
- Full overlay vs. mill-and-replace. An overlay caps the existing surface; a full removal digs the base out first. If your base is solid, the overlay costs less. If it’s had water sitting under a cracked crust for years – which we find a lot on the older original drives in Murphy – the full removal is the only honest answer, and we’ll tell you upfront which one your drive needs.
- Asphalt thickness. Thinner lifts look fine for a season and then rut around the garage apron under summer heat. Thicker lifts last longer but add to the square-foot cost. We quote the thickness in writing and stick to it.
- Base reinforcement. Some drives need a geotextile fabric layer under the asphalt where the clay subgrade is active. It’s not on every job, but skipping it on a drive that needs it is money down the drain.
- Seal coat timing. A fresh asphalt drive needs to cure before sealing, usually a season. Right after paving, sealing traps solvents and shortens the driveway’s life. If a contractor tells you to seal it the same week, ask why.
What Asphalt Driveways & Resurfacing Costs in Murphy, TX

Full asphalt paving and resurfacing here runs $3,500 – $9,000. That’s the number you’ll see on most Murphy two- and three-car driveways once the measurements and base condition are in.
Five things push a job to the low or high end:
- Square footage. A short single-car apron sits near $3,500; long driveways with a turn-around run toward the top.
- Existing base condition. Solid base means overlay pricing; a failed base means removal, excavation, and new stone, which pushes the number up fast.
- Drainage correction. If the drive runs toward the garage, or the lot’s original grading sits against a low corner, we have to re-cut and re-slope – that’s a real line item, not a surprise at the end.
- Access. Tight lots make hauling and rolling awkward, and the labor side of the quote reflects it.
- Driveway width and apron detail. Widening an apron or reworking the curb cut adds cost that actually shows up in the written estimate.
Every Groundwork estimate is written line-by-line and the price doesn’t change once the demo starts. No change orders after the fact, no “we found something” bump – that’s the whole point of the number you sign.
See the difference
Before
After
Before
After
Before
AfterWhat Murphy’s Build-Out Reality Means for Your Driveway
Murphy is essentially built out, which makes it different from the fast-growing exurbs around it. Most of our work here is infill and renovation on lots platted decades ago, not greenfield builds. That means the original plat’s drainage patterns, easements, and setbacks dictate the job more than any blank acreage would. On a tight lot, where the drive runs to the property line, we’re working within the plat’s existing easements and grading, and any resurfacing plan has to respect them.
Residential work in 75094 runs through a small-town permitting and inspection environment, so HOA and plat restrictions on developed streets matter earlier than they would in a big metro. One call to the city’s permitting office, and the plan either clears or needs a rework before work starts. We handle that step.
Then there’s the ground. North Texas black clay expands and contracts through wet-dry cycles and summer heat, so edge heaving and ponded water are the failures we see most here. On Murphy drives, we grade for drainage hard, and we don’t skip base reinforcement where the clay subgrade is active. If you’re planning a wider lot redo alongside the drive, this is part of a full Driveway & Pavers in Murphy scope, and we walk both at once.
Serving Murphy, TX – Our Local Coverage Area
We serve Murphy and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Murphy

A typical two-car driveway takes three working days: one to tear out and prep, one to grade and confirm the drainage, and one to pave and finish the edges. Larger or longer drives run four to five days. Weather shifts things, and we’ll tell you the morning of if rain is going to delay the schedule.
Usually yes, if the work affects the curb cut, the driveway apron, or the drainage pattern off the lot. Because Murphy is mostly built out, even small resurfacing jobs can run into plat restrictions on easements and setbacks. We handle the permit paperwork and the inspection sign-off as part of the job.
Sometimes – if the base underneath is solid. An overlay caps the existing asphalt and skips the demolition. We’ll probe the base and tell you honestly whether yours is a candidate or not, rather than overlay a drive that’s going to fail inside two years.
No. The number in the written estimate is the number you pay. The only exception is if you add scope mid-job, and then we give you a new written line item before we touch it. No surprise finds, no mid-job change orders.
Workmanship is covered by the 730-Day Done Right Promise. If the grading, base prep, or compaction isn’t right, we come back and fix it. That’s one of the longest workmanship guarantees in the residential construction space, and it’s in writing.
Ready for a Real Number on Your Murphy Driveway?
Call (888) 343-9048 for a free on-site estimate on asphalt driveways & resurfacing in Murphy. We walk the drive, probe the base, measure the lot, and hand you a written, line-item number – no phone quote, no guessing. Whether it’s a reseal on a drive that’s due, a full overlay, or a replacement on a failed base, you’ll know what it costs before you commit. And if you’re redoing other lot work at the same time, homeowners often pair this with Chain Link Fence in Murphy or ADU Site Prep & Utilities in Murphy – one site walk, one scope, one crew. You can also see our full Driveway & Pavers work and the wider Murphy service area.
Written by the team at Groundwork Construction Co.












