







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Wylie: What to Expect
Concrete driveways & concrete work in Wylie, TX typically run $4,500 – $12,000 for a new driveway installation, with most jobs finished in 3 – 7 days from demo to drive-on. A standard three-car apron near Wylie East High School and the Woodbridge and Kreymer Estates subdivisions lands closer to the middle of that range once you factor in removal and blackland clay base prep. Call (888) 343-9048 for a free on-site estimate.
How We Do Concrete Driveways & Concrete Work in Wylie, Step by Step

Concrete is unforgiving of shortcuts. The pour is quick; the prep around it is what determines whether your driveway is smooth in five years or cracked and heaving. Here’s the honest sequence.
Day 1: Walk the site and cut the grade
We start by marking the finished elevations against your garage slab, your fence line, and the curb. Then the existing surface comes out. A typical Wylie subdivision drive is 500 – 700 square feet, and demo runs one day with the excavated material hauled off unless it’s concrete that qualifies for recycling. You decide the driveway width and any flared apron versus a straight run at this stage, because both change the excavation footprint.
Day 1 – 2: Prep the base and address drainage
We excavate to a minimum of 4 inches of compacted base, and that number goes up wherever the soil profile is worse than expected. On former pasture lots, that’s often. Rebar goes in at 12- to 18-inch grid spacing, or post-tension cable in zones where the clay movement is aggressive. You decide here whether you want the drainage swale or French drain detail at the low side, and that decision usually saves a callback later.
Day 2: Forming and inspection
Forms get set to final grade within a quarter inch. If your project pulls a permit, we coordinate the pre-pour inspection before a single yard of concrete arrives. You walk the forms and look at the slope. This is the last chance to catch a low spot before it becomes permanent, so we ask you to look at it with us.
Day 3: Pour and finish
A standard driveway takes 5 – 10 yards of concrete delivered by truck. Finishing runs about half a day for a broom finish. You decide the finish (broom, exposed aggregate, or a decorative stamp) and any control joint layout before we start, because once the pour lands there are no do-overs.
Day 4 – 7: Cure and joint cutting
We cut control joints the day after the pour, then cover the slab to slow the cure. Texas heat pulls moisture out fast, and uncontrolled curing is what produces random cracking. You wait 7 days before driving on it and 48 – 72 hours before parking anything light. Full strength takes around 28 days, which matters if an inspector or a paving crew needs access.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for Concrete Work in Wylie
Every concrete driveway comes down to a handful of decisions. Here’s what actually changes the outcome:
- Concrete strength and mix. Standard driveway concrete runs 4,000 – 4,500 PSI. Fibers add tensile strength and cut down surface cracking, at a small increase. Higher PSI suits heavy use but doesn’t fix bad base. Base always beats mix.
- Reinforcement. Rebar at 12-inch spacing is the baseline; post-tension is the upgrade for homes where the blackland clay is most aggressive. On newer Wylie builds, post-tension is often already a slab requirement, and driveway reinforcement should match.
- Finish. Broom is standard, drains well, and holds grip in rain. Exposed aggregate adds $1.50 – $3 per square foot and gives a warmer look. Stamped decorative concrete belongs on a separate job; for a functional driveway, broom and a clean control-joint layout look sharper than they sound.
- Drainage detailing. A swale, French drain, or channel drain at the low corner. It adds cost upfront and rarely needs a fix later. That’s the trade-off most Wylie homeowners want to make.
- Width and apron flare. A wider drive means more square footage and more yard removed. It reads better from the street and matches the scale of a two-story brick-veneer home.
Where a decorative surface is the priority over structure, that’s a different job, and it pairs with Driveway & Pavers work where the design allows.
What Concrete Driveways & Concrete Work Costs in Wylie, TX

Concrete driveway installation in Wylie runs $4,500 – $12,000, and driveway replacement (demo plus new pour) runs $5,000 – $14,000. Here’s how to read the line items:
| Scope | Typical range |
|---|---|
| New concrete driveway installation | $4,500 – $12,000 |
| Driveway replacement (remove & repour) | $5,000 – $14,000 |
| Grading, base and drainage detail | Included in scope; adds 10 – 20% where drainage is complex |
Five variables move the number:
- Size and layout. A two-car straight drive is the low end. A three-car with a widened apron and a turnaround pad is the high end.
- Existing condition. Demo, removal, and haul-off push a replacement job toward the top. A driveway poured before the holidays doesn’t have this cost.
- Base and drainage. Exceptional clay and water-ponding conditions need excavation past the minimum and a drainage detail, which adds to a finished job.
- Finish and reinforcement. Exposed aggregate and post-tension add to the total.
- Permit scope. Where the lot requires a permit, permit fees and inspection timing add a step. We handle permitting and inspection coordination, and we quote it upfront with no surprises.
Our written estimates break out each line, so you see exactly what you’re paying for and what isn’t included. Give us a call at (888) 343-9048 for a free estimate.
See the difference
Before
After
Before
After
Before
AfterWhat Wylie Homes Specifically Do to This Job
Wylie is an exurb that flipped from a small farm town to a bedroom suburb in roughly two decades, so almost nothing in the housing stock predates the 1990s boom. That changes concrete driveways & concrete work in Wylie in a specific way: most of our work is new, additions, or updates on lots that were pasture 20 or 30 years ago. North Texas blackland clay expands and contracts hard with our wet-dry cycles, and on a former pasture lot with flat-to-gently-sloped grading, that movement shows up as heaving, spalling, and water ponding against garage slabs and fence lines. The counter-intuitive part; the newer builds in the Kreymer Estates and Woodbridge subdivisions aren’t immune. Their slabs and lot grades were often set to minimums on soil that stills moves. So we build the base and drainage detail for soil movement first, not for the pour. Near the original downtown grid off Ballard Avenue, the older small-frame houses have their own issues; narrower lots, tighter access, and foundations that need a gentler touch, which is where you’ll also see Door Installation in Wylie paired with this work as homes get tightened up.
Serving Wylie, TX – Our Local Coverage Area
We serve Wylie and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Concrete Driveways & Concrete Work in Wylie

Concrete driveways & concrete work in Wylie take 3 – 7 days from demo to the day you can drive on it. Demo and prep run 1 – 2 days, the pour is a single day, and curing control takes the rest; you’re on the surface after about 7 days and at full strength around day 28. Call (888) 343-9048 to schedule an estimate and a realistic timeline for your lot.
Whether you need a permit depends on the scope; a like-for-like replacement often doesn’t, while new connections, widening into an easement, or a change to grading near the curb may. We confirm the requirement with the city and pull the permits where any apply, then coordinate and pass the inspection. Call (888) 343-9048 and we’ll tell you what your specific job needs.
In most cases, yes. A driveway pour only needs moving utility lines that run under the existing surface, and we locate those before we excavate so nothing gets hit. Where a new drive has to cross an existing irrigation run or a utility trace, we work it into the plan rather than around it. Call (888) 343-9048 and we’ll walk your layout on-site.
Concrete driveway installation in Wylie runs $4,500 – $12,000, and a full replacement runs $5,000 – $14,000. The number you see on the written estimate is the number you pay; we don’t open the job and then add change orders for things we should have seen on the walk. Call (888) 343-9048 for an exact quote; estimates are free.
Every driveway job is covered by the 730-Day Done Right Promise; if it’s not done right, we make it right. Our technicians have up to 12 years of experience, arrive background-checked in uniform, and we use brands like Tamko, Boral, and Atlas where the material spec calls for them. Call (888) 343-9048 with any warranty question before you sign anything.
Get a Free Estimate for Concrete Driveways & Concrete Work in Wylie
Call (888) 343-9048 and a live person picks up, day or night. We’ll schedule a free on-site estimate, walk your drive, and hand you a written line-item quote before you commit to anything. If your project is part of a full Driveway & Pavers in Wylie scope or pairs with ADU Site Prep & Utilities in Wylie, we’ll price it together. We cover Wylie and the surrounding area. Upfront pricing, permits pulled and inspections passed, and the 730-Day Done Right Promise on the finish.
Written by the team at Groundwork Construction Co.












