







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Rowlett, TX: What It Takes and What It Costs
Door installation in Rowlett typically runs $450 to $1,900 per door depending on type, material, and whether the opening has to be reframed, and most single-door jobs are finished in one day. We handle exterior entry doors, interior doors, patio and French door sets, and garage service doors on the brick-veneer homes that make up most of this city. Call (888) 343-9048 for a free on-site estimate with a written, line-item quote.
How our crew runs a door installation from tear-out to final swing

Every door is different, but the sequence holds. Here’s what a real install looks like, stage by stage, so you know what to expect and when you’ll be asked to make a call.
- Day 1, morning: measure and confirm. We pull the existing casing and check the rough opening for plumb, square, and rot at the sill. On a 30-to-40-year-old Rowlett house, the framing has usually moved a little, so we note any shimming or header work before a single door comes off the truck. This takes 45 to 90 minutes. You confirm the final door model, swing direction, and hardware finish at this point.
- Day 1, mid-day: demo and prep. The old slab and frame come out, the opening gets cleaned, and any soft wood or damaged brick molding is replaced. On exterior doors we inspect the sill pan and flashing; a bad sill from a decade of North Texas rain is the most common thing we find. Roughly two to three hours.
- Day 1, afternoon: set and shim. The new unit goes in, gets shimmed at the hinges and lock side, checked for square, and fastened. We dry-fit the swing before we touch a finish nail. One to two hours per door.
- Day 1, evening or day 2: seal, trim, and hardware. Insulation goes in the gap, low-expansion foam fills the rest, and the casing and threshold get set. We hang the hardware and test the latch and deadbolt alignment. On a single door this closes out the same day; a set of interior doors runs into a second day.
- Final walkthrough. We open and close the door at least a dozen times, check for daylight and drafts, confirm the lock throws clean, and walk you through the 730-Day Done Right Promise in writing. Fifteen minutes, and you sign off on what you see.
Most jobs are simple enough to do in one visit. Multi-door homes or a patio door replacement on a two-story wall will stretch to two or three days, and we tell you which at the estimate so there are no surprises.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The choices you’ll actually weigh before we order
Door installation is mostly a decision job. These are the real trade-offs we walk homeowners through, with honest ranges.
- Entry door material: steel, fiberglass, or wood. Steel is the budget-friendly workhorse and holds paint well, but dents under impact and can rust at the bottom edge in humid stretches. Fiberglass is the sweet spot for Rowlett – it won’t rot, won’t dent, and handles the summer heat without warping; expect more upfront than steel. Wood looks the best and costs the most, and it needs repainting every few years.
- Frame and threshold: aluminum vs. composite vs. wood. Wood sills are the corrosion and rot weak point. Composite or aluminum thresholds cost more but survive our wet springs and clay-soil movement far better.
- Interior doors: hollow-core vs. solid-core. Hollow-core keeps the budget down and is fine for closets and lesser rooms. Solid-core adds weight, quiets a hallway, and holds up to kids and pets. The price gap is real per door but small in the room budget.
- Glass and finish. A decorative glass insert or sidelite adds light and curb appeal and pushes the price up; a plain panel keeps it lean. Hardware finish – satin nickel, matte black, bronze – should match what’s already on the house.
- Brand and grade. For exterior units we often spec PGT or a comparable fiberglass system because they hold up to North Texas storms. For patio doors, a well-sealed sliding or French unit is worth the extra. Atlas and Boral show up in our trim and jamb packages.
Pick what suits the house and your timeline, not just the cheapest option on the page.
What Door Installation costs in Rowlett, TX

Expect $450 to $1,900 for a single door installation in Rowlett, with most entry doors landing around $700 to $1,400 installed. Here’s what pushes the number up or down.
| Job | Typical installed range |
|---|---|
| Interior door (hollow-core) | $450 – $800 |
| Interior door (solid-core) | $600 – $1,100 |
| Exterior entry door (steel or fiberglass) | $700 – $1,400 |
| Premium fiberglass or wood entry | $1,200 – $1,900 |
| Patio / French door set | $1,800 – $4,500 |
| Garage service door | $500 – $1,100 |
What moves the price: the door itself (steel vs. fiberglass vs. wood), whether the rough opening needs reframing, rot or sill repair uncovered during demo, hardware grade, and whether a permit is required for a new opening. Relocating a door to a new wall is a bigger project than a swap-in-place, and we price it separately.
A written estimate from us spells out the door model, labor, trim, hardware, disposal of the old unit, and the workmanship warranty. What it won’t include unless we flag it upfront: unexpected rot repair, painting or staining beyond a basic finish coat, or drywall patching if the opening changes.
See the difference
Before
After
Before
After
Before
AfterWhat Rowlett homes specifically do to a door installation
Rowlett was built out as planned subdivisions through the 1980s and 2000s, and most of the housing stock is brick-veneer tract homes on slab-on-grade with wood framing. That matters here because the doors and jambs in these houses are now 20 to 40 years old. We pull a lot of sticking, sagging doors in two-story homes around the 75088 and 75089 ZIP codes, and the culprit is usually either a hinge-side jamb that’s swelled from humidity or a slab that’s shifted on the expansive clay. If the frame is out of square, we correct it – a new door in a crooked opening will drag within a month.
On lake-adjacent lots toward the Lake Ray Hubbard shoreline, we see more moisture-driven rot at the sill and threshold, so composite or aluminum thresholds are the right call. The city permits new door openings through the City of Rowlett, and HOA architectural review in most subdivisions applies to exterior door color and style changes – check before you order. If the project grows into a full exterior refresh, this is often scheduled as part of a Windows & Doors in Rowlett scope, and for the wider selection of door styles and systems you can browse our Windows & Doors service. We cover all of Rowlett, and homeowners often pair this with Cabinets & Countertops in Rowlett when a kitchen refresh is on the same schedule – or with a Garage Conversion ADU in Rowlett that adds a whole new set of doors.
Serving Rowlett, TX – Our Local Coverage Area
We serve Rowlett and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Door Installation in Rowlett

Most single-door installations are finished in one day, and a set of four to six interior doors takes two days. Patio and French door sets that require header or framing work can run two to three days. We give you a realistic finishing day in the written estimate.
A swap-in-place door in an existing opening usually doesn’t require a permit, but a new door opening cut into a wall does. We pull the permit for any new opening and schedule the inspection so you’re covered. Call (888) 343-9048 and we’ll tell you which applies to your job.
Yes – most door installations fit in the existing rough opening and require no structural, plumbing, or electrical changes. That’s the standard swap and it’s what most homeowners want. If the door has to relocate to a new wall, that becomes a framing and drywall job, and we tell you that at the estimate.
Single doors run $450 to $1,900 installed, with most entry doors landing around $700 to $1,400. The door material, frame condition, and whether the opening needs reframing are the biggest swings. Call (888) 343-9048 for an exact quote – estimates are free.
Every door installation is covered by the 730-Day Done Right Promise: if something we installed isn’t right, we make it right. The door manufacturer’s warranty covers the unit itself. You get both in writing at final walkthrough.
Get a free Door Installation estimate in Rowlett
Call (888) 343-9048 to schedule a free on-site estimate for door installation in Rowlett. A live person answers around the clock, so you’re never stuck in voicemail. We’ll measure the openings, walk you through door options and hardware, and hand you a written, line-item quote with the 0% financing for 18 months and $1,000 off projects over $10,000 available if the job grows past a single door.
Written by the team at Groundwork Construction Co.












