







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Garland, TX: What the Job Actually Involves
Paver driveways in Garland typically run $7,000 to $18,000 for a standard two-car run with base, edge restraint and a compacted finish, and a normal job takes three to five working days once demolition starts. The number moves with square footage, how bad the old surface is, and which units you choose. Call (888) 343-9048 for a free on-site estimate before you commit to a layout or a paver grade.
Here’s the part most homeowners in Garland are actually dealing with: a cracked, heaved slab or a worn gravel strip at the end of a 1950s or 1960s ranch, where the original concrete has already taken a few hard decades of blackland clay movement underneath it. Water is likely pooling somewhere, and you’re deciding whether to patch again or rebuild it done.
How We Build Paver Driveways: Day by Day

Paver driveways depend on what’s underground, not what’s on top. That’s why the first morning is almost entirely about the base, and why the schedule below lets the subgrade tell us what the job really needs.
- Day 1 – Tear-out and layout. We remove the existing slab, gravel or asphalt, haul it off, and mark the perimeter with string lines and a compaction check on the subgrade. You confirm the finish grade at your garage apron and where water should run. If your old driveway was draining toward the house, we fix that now, not later.
- Day 1-2 – Excavation and base prep. We excavate 6 to 9 inches deep, depending on the load and your soil condition, then lay and compact the crushed stone base in lifts. Each lift gets compacted before the next one goes down. A base that isn’t compacted in stages is the reason paver driveways fail early in North Texas clay.
- Day 2-3 – Edge restraint and sand setting bed. We set the edge restraint on a concrete collar so the units can’t creep under tire load, then screed a level sand bed. This is also where you confirm the running bond, herringbone or basketweave pattern and the joint width you want.
- Day 3-4 – Paver installation. The majority of the driveway goes down here. We cut field units along the edges and around curves with a wet saw, and keep consistent joint spacing so the finished surface locks together. Expect dust and noise on this day; the equipment matters more than the mess.
- Day 4-5 – Compact, joint sand, clean-up. We compact the finished field, sweep and vibrate polymeric joint sand into the gaps, then do a final rinse and walkthrough. You sign off with us, and your written workmanship statement comes with it.
You make three real decisions along the way: finish grade and drainage direction, paver style and pattern, and unit color. We ask for those at the estimate and confirm them on day one so nobody’s scrambling on day three.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for Paver Driveways
Most of the price gap for paver driveways in Garland comes down to unit choice and base depth, not labor. Here’s what’s actually on the table:
- Concrete interlocking pavers (the standard). The most common and most durable choice, with 6×9 and 4×8 formats, a full range of earth tones, and patterns like herringbone or running bond. They’re repairable unit-by-unit if one cracks. Expect the middle-to-upper part of the range.
- Clay or brick pavers. Warmer color, harder surface, and a classic look that suits older Garland brick veneer homes well. They cost more per square foot and are less forgiving if the base is thin. Worth it on a long-horizon home, less so if you might resell soon.
- Permeable pavers. Open-joint or gapped units over a drainage bed let water soak in instead of sheeting toward the street. These make sense on Garland lots already close to impervious-cover limits, since they change how your coverage is counted. We check that with you up front.
- Polymeric vs. plain joint sand. Polymeric sand locks joints and resists washout, which matters in Garland’s wet-spring/dry-summer swings. It costs a bit more and is the honest choice for a driveway that takes tire load.
Brand partners in this category include Belgard if you want a named system. We won’t upsell a premium unit onto a base that won’t hold it; that’s a waste of your money.
What Paver Driveways Cost in Garland, TX

Plan on $7,000 to $18,000 for paver driveways in Garland. A typical two-car drive lands in the middle of that band. Five things move the number:
- Square footage and complexity. Straight runs cost less per square foot than curves, islands or tight aprons against a garage door.
- Existing condition. A cracked, heaved slab needs full removal and haul-off. A sound surface may cost less to strip.
- Base material and excavation depth. Clay-heavy Garland soil sometimes needs a deeper, more heavily compacted base, which adds labor and stone.
- Paver grade and pattern. Standard interlocking concrete units sit at the low-to-mid range; clay brick and intricate patterns push toward the top.
- Drainage and edge work. Regrading toward the street, a drainage strip or a concrete collar adds money but prevents the water problems that wreck a driveway early.
Your written estimate is line-itemed: unit type, square footage, base depth, edge restraint, joint sand, haul-off and any drainage work. It does not include future sealing, which is a separate job down the line, or changes you request mid-job. The number we quote is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Garland Homes Do to This Job
Most of the houses we do paver driveways on in Garland went up between the 1950s and 1970s, single-story brick ranches with original concrete or gravel aprons. Out toward the 75044 and 75043 subdivisions, the slab is newer and often the base is the story instead of the surface. Inside the older grid in 75040, 75041 and 75042, the lots are narrow and frequently at or near the city’s impervious-cover limits. That changes how much of the footprint can be hard surface and where water needs to go, so we plan drainage and coverage before we ever cut a slab. The blackland clay under Garland expands and contracts with the wet springs and dry summers, which is why we don’t treat base prep as optional. The failure modes we see most: heaved slabs from clay movement, cracks at the garage apron, and edges that have washed out because there was no concrete collar.
If you’re partway through a larger project, Driveway & Pavers in Garland covers the broader scope, and many homeowners pair this with Door Installation in Garland to finish the street-facing look. We cover the Garland area and surrounding neighborhoods, so you’re not waiting on a crew from out of town. Our Driveway & Pavers service page shows the full material set we work with. If a redo is also on your mind inside, Cabinets & Countertops in Garland is a common pairing once the outside is done.
Serving Garland, TX – Our Local Coverage Area
We serve Garland and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Paver Driveways in Garland

Most jobs run three to five working days from tear-out to final compaction. A simple straight two-car run can finish faster; a curved drive with poor existing drainage can push toward a week. Weather matters, and we schedule around it rather than rushing the base.
Replacing a driveway in the same footprint usually doesn’t require a permit, but expanding the hard surface, changing drainage or approaching impervious-cover limits can. We check the scope against the lot and pull what’s needed. Call (888) 343-9048 and we’ll tell you what your specific driveway requires.
Expect $7,000 to $18,000 for a standard two-car paver driveway, with the total driven by square footage, base depth, unit grade and drainage work. Call (888) 343-9048 for an exact quote; estimates are free and line-itemed.
No, not on our scope. We do a subgrade inspection before quoting so surprises are priced in. If we find something hidden that changes the job, we stop and talk to you before touching your wallet. The number you see is the number you pay.
Every paver driveway is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. It’s one of the longest workmanship guarantees in residential construction, and it applies to this job in writing.
Get a Free Estimate on Paver Driveways in Garland
We’ll walk your driveway, check the base and drainage, and hand you a written line-item quote for paver driveways in Garland at no cost. Call (888) 343-9048 – a live person answers 24/7, not a voicemail. Ask about our current offer of $1,000 off projects over $10,000 and 0% financing for 18 months.
Written by the team at Groundwork Construction Co.












